Call settings
Send my caller ID
(network service)—You can set your
phone number to be displayed to (
Yes
) or hidden from (
No
)
the person to whom you are calling, or the value may be
set by your network operator or service provider when you
make a subscription (
Set by network
).
Call waiting
(network service)—If you have activated call
waiting, the network notifies you of a new incoming call
while you have a call in progress. Select
Activate
to
request the network to activate call waiting,
Cancel
to
request the network to deactivate call waiting, or
Check
status
to check if the function is active or not.
Reject call with SMS
—Select
Yes
to send a text message
to a caller informing why you could not answer the call.
See ‘Answer or reject a call’, p. 33.
Message text
—Write a text to be sent in a text message
when you reject a call.
Automatic redial
—Select
On
, and your device makes a
maximum of ten attempts to connect the call after an
Tools
103
Copyright © 2006 Nokia. All rights reserved.
unsuccessful call attempt. To stop automatic redialling,
press .
Summary after call
—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
Speed dialling
—Select
On
, and the numbers assigned to
the speed dialing keys (
-
) can be dialed by pressing
and holding the key. See also ‘Speed dial a phone number’,
p. 32.
Anykey answer
—Select
On
, and you can answer an
incoming call by briefly pressing any key under the slide
cover.
Line in use
(network service)—This setting is shown only if
the SIM card supports two subscriber numbers, that is, two
phone lines. Select which phone line you want to use for
making calls and sending text messages. Calls on both lines
can be answered irrespective of the selected line. If you
select
Line 2
and have not subscribed to this network
service, you will not be able to make calls. When line 2 is
selected,
is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold
in the standby mode.
Line change
(network service)—To prevent line selection,
select
Line change
>
Disable
if supported by your SIM
card. To change this setting, you need the PIN2 code.